HPE ProLiant ML110 Gen10

a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
• Server in rack mode: Remove the server from the rack.
• Server in tower mode: Position the tower server for hardware configuration.
5.
Remove the access panel.
6.
Remove the front bezel.
7. Remove the PCI air bale.
8.
Remove the system air bale.
9. Disconnect the iLO Service Port cable from the system board.
10. Remove the iLO Service Port cable:
a.
Remove the screw.
b.
Release the cable secured in the cable clip on the chassis.
c.
Pull the iLO Service Port cable away from the front panel.
To replace the component, reverse the removal procedure.
Removing and replacing the serial port cable
Prerequisites
Before you perform this procedure, make sure that you have a
50 mm hex nut screwdriver available.
Removal and replacement procedures
49