2. Do one of the following:
• Lock the internal locker.
• Leave the internal locker in unlock position if you want to access the front panel any time without removing the
access panel.
3.
Install the access panel.
4.
Do one of the following:
• Server in rack mode:
Install the server into the rack.
• Server in tower mode: Return the server to an upright position.
5.
Connect all peripheral cables to the server.
6.
Connect each power cord to the server.
7.
Connect each power cord to the power source.
8.
Power up the server.
Install the server into the rack
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. Grasp the tray notch and extend the server tray out of the rack.
Removal and replacement procedures
40
To Next Page
Loading...
