HPE ProLiant ML110 Gen10

For more information about battery replacement or proper disposal, contact an authorized reseller or an authorized
service provider.
Removing and replacing an energy pack
Procedure
1.
Power down the server.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
• Server in rack mode:
Remove the server from the rack.
• Server in tower mode:
Position the tower server for hardware configuration.
5. Remove the access panel.
6.
Remove the PCI air bale.
7. Remove the system air bale.
8. Remove the energy pack.
Removal and replacement procedures
82