Install the access panel
Procedure
1. Install the access panel:
a. Place the access panel on the chassis, and slide it towards the front of the server.
b. Tighten the thumbscrews.
2.
If a Kensington security cable was removed, connect it to the rear panel. See the security cable documentation for
instructions.
3.
Do one of the following:
• Server in rack mode: Install the server into the rack.
• Server in tower mode: Return the server to an upright position.
4.
Connect all peripheral cables to the server.
5.
Connect each power cord to the server.
6.
Connect each power cord to the power source.
7.
Power up the server.
Install the front bezel
Procedure
1. Install and close the front bezel.
Removal and replacement procedures
39
To Next Page
Loading...
