Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripherals cables from the server.
4. If a Kensington security cable is installed, disconnect it from the rear panel. See the security cable documentation for
instructions.
5. Fully extend the server out of the rack:
a. Loosen the server tray thumbscrews.
b. Hold the tray notch to slide the server out of the rack.
6.
Lift the server from the tray.
Removal and replacement procedures
32
To Next Page
Loading...
