FULLTEST3
EN - 3
1. SAFETY PRECAUTIONS AND PROCEDURES
CAUTION
For your own safety and to avoid damaging the instrument follow the
procedures described in this instruction manual and read carefully all
notes marked with this symbol
This instrument complies with safety Standards IEC/EN61557-1 and IEC/EN61010-1
related to electronic measuring instruments. When taking measurements:
x Avoid doing this in humid or wet places - make sure that humidity is within the
limits indicated in section “Environmental conditions”
x Avoid doing this in rooms where explosive gas, combustible gas, steam or
excessive dust is present
x Keep you insulated from and do not touch the object under test, any exposed
metal part such as test lead ends, sockets, fixing objects, circuits etc
x Avoid doing this if you notice anomalous conditions such as breakages,
deformations, fractures, blind display etc.
The following symbols are used on the instrument and in this manual:
Warning of a potential danger, comply with instruction manual.
Caution, dangerous voltage. Danger of electrical shock.
UUT
Unit under test
To Next Page
Loading...
