FULLTEST3
EN - 87
Replacement Fuse F4
¾ The fuse F4 is damaged if the message "F4 FUSE" appears on the display in the
RPE function
1. Open the fuse holder F4 (see Fig. 2 – part 15) by using an appropriate screwdriver
2. Remove the defective fuse and replace it with a new one (see §)
3. Replace the fuse holder.
CAUTION
If any fuse blows several times (for example in case of operating
error) the instrument must be sent in to the service department
10.4. END OF LIFE
CAUTION: this symbol indicates that the equipment and its accessories must be
collected separately and disposed of in the right way.
To Next Page
Loading...
