Parameter Description
IP address Camera IP address. This parameter is
available only when you set Ways to obtain
IP to Manual.
IP addresses starting with 127 are invalid.
You must enter an IP address starting with
another value that ranges from 1 to 223.
Subnet mask Subnet mask of the IPC.
Gateway IP address Gateway IP address of the IPC.
Preferred DNS server IP address of the active domain server.
Alternate DNS server IP address of the standby domain server.
Step 3 Click Save.
----End
3.2 Setting platform Connection Parameters
IPCs can register with the video surveillance platform using GB/T 28181, SDK, ONVIF, or
GENETEC to view live video viewing, set parameters, and control the PTZ.
NOTE
l Parameters to be set vary depending on protocols. IPCs can connect to the video surveillance platform
successfully only when parameter setting is completed both on the video surveillance platform and IPCs.
l This section describes how to set parameters on IPCs. For details about how to set parameters on the
video surveillance platform, see the corresponding documentation of the platform.
3.2.1 Setting Parameters for an SDK-based Connection
When the SDK protocol is used when connecting IPCs to the platform, you need to set the
SDK parameters.
Procedure
Step 1 Choose Settings > System Configuration > Platform Connection Parameters.
The page for setting platform connection parameters is displayed.
Step 2 Choose Active SDK registration in Protocol type.
The SDK parameter setting page is displayed.
IPC6221-VRZ-SP
Configuration Guide
3 Setting Basic Parameters
Issue 02 (2016-04-06) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11
To Next Page
