Huawei IPC6221-VRZ-SP - Setting Bandwidth Adaptive Parameters

NOTE
l When the smoothness coefficient is greater than 1, the limited bandwidth is 50 Mbit/s. When the
smoothness coefficient is 100, the limited bandwidth is 1 Mbit/s.
l A larger smoothness coefficient indicates a stricter restriction on the speed for sending data and a stronger
smoothness effect.
Step 4 Click Save.
----End
7.4 Setting Bandwidth Adaptive Parameters
With the bandwidth adaptive function enabled, the IPC will use an appropriate bit rate that
best suits the current network conditions to transfer video images. This approach ensures the
image quality.
Prerequisites
Bandwidth adaptive parameters are available only when:
l Stream type is set to Primary stream.
l Coding protocol is set to H.264.
l Bit rate type is set to Constant bit rate.
l The dynamic bit rate function is disabled.
NOTE
Do not enable the bit rate stream smoothing function when the self-adaptive bandwidth function is enabled.
Otherwise, the bandwidth may be inaccurately calculated.
Procedure
Step 1 Choose Settings > Network Configuration > Bandwidth Adaptive Parameters.
The Bandwidth Adaptive Parameters page is displayed, as shown in Figure 7-7.
Figure 7-7 Bandwidth Adaptive Parameters page
Step 2 Select Bandwidth adaptive.
Step 3 Click Save.
NOTE
You can click to view the bit rate of the current primary stream.
----End
IPC6221-VRZ-SP
Configuration Guide
7 Setting Network Parameters
Issue 02 (2016-04-06) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
57