Parameter Description
Privacy This parameter is available only when you set Version to v3
and Security level to Authentication and privacy.
Key used for IPC authentication.
NOTE
It is recommended that the key meet the following conditions:
l The key consists of 8 to 20 characters.
l The key contains at least two types of the following: lowercase
letters (a to z), uppercase letters (A to Z), digits (0 to 9), and special
characters (including the space character and the following: `~!@#$
%^&*()-_=+\|[{}];:'",<.>/?).
l The key must be different from the user name or the reverse text of
the user name.
l To improve security, the value of Privacy must be different from
Authentication protocol.
Step 4 Click OK.
The SNMP Parameters page is displayed.
Step 5 Click Save.
----End
7.6.3 Configuring SNMP v3 User Information
When SNMP v3 is used, the NMS visits the IPC using a user account in secure access mode.
Different user accounts have different access rights.
Context
When SNMP v3 is used, you can configure a maximum of three SNMP v3 users. This section
mainly describes how to add a new SNMP v3 user.
Procedure
Step 1 Choose Settings > Network Configuration > SNMP Parameters.
The SNMP Parameters page is displayed, as shown in Figure 7-13.
Figure 7-13 SNMP Parameters page
IPC6221-VRZ-SP
Configuration Guide
7 Setting Network Parameters
Issue 02 (2016-04-06) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
62
To Next Page
Loading...
