NOTE
A Chinese word occupies three characters in this Web page. If you attempt to set the track name to
Chinese words, the track name can contain a maximum of 10 Chinese words.
2. Click Add Preset.
The Add preset to guard tour page is displayed.
3. Select specified preset positions from the Preset drop-down list box and set the Dwell
duration.
NOTE
– For the cameras with PTZs connected, the value of Dwell duration(s) must be longer than the time
required for rotating a camera from a previous preset to the specified preset.
– For the cameras with PTZs connected, if you adjust the rotation speed of the PTZ camera after
configuring a tour track, the value of Dwell duration(s) may be smaller than the time required for
rotating a camera from a previous preset to the specified preset. In this case, reset Dwell
duration(s).
4. Click OK.
The Create tour track page is displayed.
5. Add more preset positions by following the preceding steps.
Step 4 Click Save.
The tour track is successfully added.
NOTE
l To enable a tour track, select the tour track and click Running.
l To disable a tour track that is running, select the tour track and click Stop.
l You can enable only one tour track at a time. If a tour track has been enabled and you enable another tour
track, the tour track that has been enabled will automatically stop.
l You can view the tour track status in the Status column.
l To modify or delete a tour track, select it and click Modify or Delete.
l To modify a tour track, you must stop the tour track first.
----End
IPC6221-VRZ-SP
Configuration Guide
8 Setting PTZ Control Parameters
Issue 02 (2016-04-06) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
72
To Next Page
