When you install an OT terminal, the crimping sleeve is installed as shown in
Figure 4-131, where A is correct and B is incorrect.
Figure 4-131 Installing an OT terminal, showing the orientation of
crimping sleeve
b. Place the spring washer and at washer in turn, mount a matching screw,
and fasten it clockwise, as shown in Figure 4-132.
Figure 4-132 Installing two terminals back to back
Ensure that the OT terminal is not in contact with other terminals or
metal components.
c. Move the cable slightly and ensure that it is securely connected, as shown
in Figure 4-133.
HUAWEI NetEngine 8000 F
Hardware Guide 4 Hardware Installation and Parts Replacement
Issue 05 (2023-03-31) Copyright © Huawei Technologies Co., Ltd. 474
To Next Page
Loading...
