Ports
Table 3-20 Port description
Port Number Port Type
0 to 19, 28 to 63 100GE/50GE/40GE
20 to 27 400GE/100GE/50GE/40GE
NOTE
1. Port 20 shares 400G bandwidth with ports 8, 9, and 12. Port 21 shares 400G bandwidth
with ports 10, 11, and 14. Port 22 shares 400G bandwidth with ports 13, 16, and 17.
Port 23 shares 400G bandwidth with ports 15, 18, and 19. As (1) shown in Port
description
2. Port 24 shares 400G bandwidth with ports 28 and 29. Port 25 shares 400G bandwidth
with ports 30 and 31. Port 26 shares 400G bandwidth with ports 32 and 33. Port 27
shares 400G bandwidth with ports 34 and 35. As (2) shown in Port description
3. Ports 36-51 support 4*25G and 4*10G breakout.
4. When ports 20 to 25 are
congured to work at 400 Gbit/s can support FlexE, but cannot
support FlexE bonding.
5. When port 20, 21, 22, 23, 24, or 25 is congured to work at 50 Gbit/s or 100 Gbit/s, it
still supports FlexE, and ports in the same group support FlexE bonding if these ports
work at the same speed. The supported port groups are {20, 8, 9, and 12}, {21, 10, 11,
and 14}, {22, 13, 16, and 17}, {23, 15, 18, and 19}, {24, 28, and 29}, and {25, 30, and
31}.
6. Do not use 100GE0/1/0 to 100GE0/1/7 and 100GE0/1/37 to 100GE0/1/46 as trunk
member interfaces. Otherwise, the board bandwidth is
aected.
Figure 3-11 Port description
HUAWEI NetEngine 8000 F
Hardware Guide 3 Hardware Description
Issue 05 (2023-03-31) Copyright © Huawei Technologies Co., Ltd. 48
To Next Page
Loading...
Need help?
General
