Huawei Quidway S3100 Series

Operation Manual – GVRP
Quidway S3100 Series Ethernet Switches Chapter 1
GVRP Configuration
Huawei Technologies Proprietary
1-7
III. Configuration procedure
z Configure switch A:
# Enable GVRP globally.
<Quidway> system-view
[Quidway] gvrp
# Set the port Ethernet1/0/1 to a Trunk port, and allow all VLAN packets to pass through
the port.
[Quidway] interface Ethernet1/0/1
[Quidway-Ethernet1/0/1] port link-type trunk
[Quidway-Ethernet1/0/1] port trunk permit vlan all
# Enable GVRP on the Trunk port.
[Quidway-Ethernet1/0/1] gvrp
z Configure switch B:
# Enable GVRP globally.
<Quidway> system-view
[Quidway] gvrp
# Set the port Ethernet1/0/2 to a Trunk port, and allow all VLAN packets to pass through
the port.
[Quidway] interface Ethernet1/0/2
[Quidway-Ethernet1/0/2] port link-type trunk
[Quidway-Ethernet1/0/2] port trunk permit vlan all
# Enable GVRP on the Trunk port.
[Quidway-Ethernet1/0/2] gvrp