Huawei Quidway S3100 Series

Operation Manual – Stack&Cluster
Quidway S3100 Series Ethernet Switches Chapter 2
Cluste
r
Huawei Technologies Proprietary
2-10
2.3.2 Enabling NTDP Globally and for Specific Ports
Table 2-10 Enable NTDP globally and for specific ports
Operation Command Description
Enter system view
system-view
—
Enable system
NTDP
ntdp enable
Required
Enter Ethernet port
view
interface interface-type
interface-number
—
Enable NTDP for
the port
ntdp enable
Required
2.4 Intra-Cluster Configuration
Table 2-11 Configure a cluster
Operation Command Description
Enter system view
system-view
—
Enter cluster view
cluster
—
Add a candidate
device to a cluster
add-member
[ member-number ]
mac-address H-H-H
[ password password ]
This is to add a new member.
The member-number, H-H-H
and password arguments are
the ID, MAC address and
password of the device to be
added to the cluster.
Remove a member
device from the
cluster
delete-member
member-num
Optional
This is to remove a member
device from the cluster.
Reboot a specified
member device
reboot member
{ member-num |
mac-address H-H-H }
[ eraseflash ]
Optional
Quit cluster view
Quit
—
Quit system view
Quit
—
Switch between
the management
device and a
member device
cluster switch-to
{ member-num |
mac-address H-H-H |
administrator }
Optional
This is to switch to the
member device identified by
the member-num or H-H-H
argument.