Huawei Quidway S3100 Series User Manual

Operation Manual – FTP and TFTP
Quidway S3100 Series Ethernet Switches Chapter 1
FTP and TFTP Configuration
Huawei Technologies Proprietary
1-3
1.1.2 FTP Configuration: A Switch Operating as an FTP Server
I. Prerequisites
A switch operates as an FTP server. A remote PC operates as an FTP client. The
network operates properly, as shown in
Figure 1-1.
Following configurations are performed on the FTP server:
z Creating local users
z Setting local user passwords
z Setting the password display mode for the local user
z Configuring service types for the local users
(For the information about these configurations, refer to these commands in “AAA and
RADIUS Configuration” module: local-user, local-user password-display-mode,
password, and service-type.)
II. Configuration procedure
Table 1-3 Configure an FTP server
Operation Command Description
Enter system view
system-view
—
Enable the FTP
server function
ftp server enable
Required
By default, the FTP server
function is disabled.
Set the connection
idle time
ftp timeout minute
Optional
The default connection idle
time is 30 minutes.
Display the
information about a
switch operating as
an FTP server
display ftp-server
Display the
information about
the FTP clients
display ftp-user
You can execute these two
commands in any view.

Huawei Quidway S3100 Series Specifications

General

Brand	Huawei
Model	Quidway S3100 Series
Category	Switch
Language	English