Huawei Quidway S3100 Series

Operation Manual – AAA&RADIUS
Quidway S3100 Series Ethernet Switches Chapter 1
AAA&RADIUS Configuration
Huawei Technologies Proprietary
1-18
In an actual network environment, you can configure the above parameters as required.
But you should configure at least one authentication/authorization server and one
accounting server, and at the same time, you should keep the RADIUS service port
settings on the switch consistent with those on the RADIUS servers.
 Note:
Actually, the RADIUS protocol configuration only defines the parameters used for
information exchange between the switch and the RADIUS servers. To make these
parameters take effect, you must reference the RADIUS scheme configured with these
parameters in an ISP domain view. For specific configuration commands, refer to
section
1.3 "AAA Configuration".
1.5.1 Creating a RADIUS Scheme
The RADIUS protocol configuration is performed on a RADIUS scheme basis. You
should first create a RADIUS scheme and enter its view before performing other
RADIUS protocol configurations.
Table 1-11 Create a RADIUS scheme
Operation Command Description
Enter system view
system-view
—
Create a RADIUS
scheme and enter its
view
radius scheme
radius-scheme-name
Required
By default, a RADIUS scheme
named "system" has already
been created in the system.
Caution:
A RADIUS scheme can be referenced by multiple ISP domains simultaneously.
1.5.2 Configuring RADIUS Authentication/Authorization Servers
Table 1-12 Configure RADIUS authentication/authorization server
Operation Command Description
Enter system view
system-view
—