Huawei Quidway S3100 Series

Operation Manual – Stack&Cluster
Quidway S3100 Series Ethernet Switches Chapter 2
Cluste
r
Huawei Technologies Proprietary
2-9
Operation Command Description
Configure an
internal SNMP
host for a cluster
snmp-host ip-address
Optional
Quit cluster view
Quit
—
Quit system view
Quit
—
II. Configuring a cluster automatically
Table 2-8 Configure a cluster automatically
Operation Command Description
Enter system view
system-view
—
Configure a cluster
automatically
Auto-build [ recover ]
Required
This is to set up a cluster
based on your instructions.
2.3 Member Device Configuration
Member device configuration involves:
z Enabling NDP globally and for specific ports
z Enabling NTDP globally and for specific ports
z Enabling the cluster function
2.3.1 Enabling NDP Globally and for Specific Ports
Table 2-9 Enable NDP globally and for specific ports
Operation Command Description
Enter system view
system-view
—
Enable NDP
globally
ndp enable
Required
Enable NDP for
specified ports
ndp enable interface
port-list
Optional
Enter Ethernet port
view
interface interface-type
interface-number
—
Enable NDP for the
port
ndp enable
Required