Huawei Quidway S3100 Series User Manual

Operation Manual – Information Center
Quidway S3100 Series Ethernet Switches Chapter 1
Information Cente
r
Huawei Technologies Proprietary
1-6
 Note:
Running the info-center synchronous command during debug information collection
may result in a command prompt echoed after each item of debug information. To
avoid unnecessary output, it is recommended that you disable synchronous terminal
output in such cases.
1.2.2 Enabling Information Output to a Log Host
Table 1-5 lists the related configurations on the switch.
Table 1-5 Enable information output to a log host
Operation Command Description
Enter system view
system-view
—
Enable the
information center
info-center enable
Optional
By default, the information
center is enabled.
Enable information
output to a log host
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number | language
{ chinese | english } ]
Required
By default, the switch does
not output information to
the log host.
Be sure to set the correct
IP address. A loopback IP
address will cause an error
message prompting invalid
address.
Configure the
source interface
through which log
information is sent
to the log host
info-center loghost source
interface-type interface-number
Optional
Define an
information source
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } * { level severity | state
state } * ]
Required
Set the format of
the time stamp to
be sent to the log
host
info-center timestamp
loghost { date | no-year-date |
none }
Optional

Huawei Quidway S3100 Series Specifications

General

Brand	Huawei
Model	Quidway S3100 Series
Category	Switch
Language	English