Huawei Quidway S3100 Series

Operation Manual – MSTP
Quidway S3100 Series Ethernet Switches Chapter 1
MSTP Configuration
Huawei Technologies Proprietary
1-19
I. Configuration procedure (in system view)
Table 1-12 Configure the maximum transmitting speed for specified ports in system
view
Operation Command Description
Enter system view
system-view
—
Configure the
maximum
transmitting speed
for specified ports
stp interface interface-list
transmit-limit packetnum
Required
The maximum transmitting
speed of all Ethernet ports on
a switch defaults to 3.
II. Configuration procedure (in Ethernet port view)
Table 1-13 Configure the maximum transmitting speed in Ethernet port view
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Configure the
maximum
transmitting speed
stp transmit-limit
packetnum
Required
The maximum transmitting
speed of all Ethernet ports on
a switch defaults to 3.
As the maximum transmitting speed parameter determines the number of the
configuration BPDUs transmitted in each Hello time, set it to a proper value to avoid
MSTP from occupying too many network resources. The default is recommended.
III. Configuration example
# Set the maximum transmitting speed of Ethernet1/0/1 port to 5.
z Configure the maximum transmitting speed in system view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] stp interface ethernet1/0/1 transmit-limit 5
z Configure the maximum transmitting speed in Ethernet port view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface ethernet1/0/1
[Quidway-Ethernet1/0/1] stp transmit-l