Huawei Quidway S3100 Series User Manual

Operation Manual – Information Center
Quidway S3100 Series Ethernet Switches Chapter 1
Information Cente
r
Huawei Technologies Proprietary
1-9
 Note:
z When there are multiple Telnet users or dumb terminal users, some configuration
parameters (including module filter, language and severity level threshold settings)
are shared between them. In this case, change to any such parameter made by one
user will also be reflected on all other user terminals.
z To view debug information of specific modules, you need to set the information type
as debug in the info-center source command, and enable debugging on
corresponding modules with the debugging command as well.
To view output debug/log/trap information on the monitor terminal, you should also
enable the corresponding debug/log/trap display on the switch.
For example, to view log information of the switch on a monitor terminal, you need to
not only enable log information output to the monitor terminal, but also enable log
terminal display with the terminal logging command.
Perform the following configuration in user view.
Table 1-9 Enable debug/log/trap terminal display
Operation Command Description
Enable the
debug/log/trap
terminal display
function
terminal monitor
Optional
By default, this function is enabled
for console user.
Enable debugging
terminal display
terminal debugging
Optional
By default, debugging terminal
display is disabled for terminal
users.
Enable logging
terminal display
terminal logging
Optional
By default, logging terminal display
is enabled for console users.
Enable trapping
terminal display
terminal trapping
Optional
By default, trapping terminal display
is enabled for terminal users.

Huawei Quidway S3100 Series Specifications

General

Brand	Huawei
Model	Quidway S3100 Series
Category	Switch
Language	English