Huawei Quidway S3100 Series

To Next Page

To Previous Page

Operation Manual – System Maintenance and Debugging

Quidway S3100 Series Ethernet Switches Chapter 3

IP Performance Configuration

Huawei Technologies Proprietary

3-3

z Use the terminal debugging command to output the debugging information to the

console.

z Use the debugging udp packet command to enable UDP debugging to track

UDP data packets.

Main Page

Section 110
- Default Chapter9
  - Product Overview9
  - Table of Contents10
- Chapter 1 Product Overview11
- Chapter 2 Network Design19
  - MAN Access Solution19
  - Education Network Solution19
Section 222
- Chapter 1 CLI Overview23
Section 334
- Default Chapter36
  - Chapter 1 Logging into an Ethernet Switch36
  - Chapter 2 Logging in through the Console Port39
- Chapter 3 Logging in through Telnet56
- Chapter 4 Logging in Using Modem74
- Chapter 5 Logging in through Web-Based Network Management System81
  - Introduction83
- Chapter 6 Logging in through NMS83
  - Connection Establishment Using NMS84
- Chapter 7 Controlling Login Users85
Section 494
- Chapter 1 VLAN Configuration95
- VLAN Configuration96
- Displaying a VLAN97
- VLAN Configuration Example98
Section 5101
- Chapter 1 Management VLAN Configuration102
- Chapter 2 DHCP/BOOTP Client Configuration107
Section 6113
- Chapter 1 GVRP Configuration114
- Introduction to GVRP114
- GVRP Configuration117
  - Configuration Prerequisite117
  - Configuration Procedure117
- Configuration Example119
- Displaying GVRP119
Section 7122
- Chapter 1 Basic Port Configuration123
- Ethernet Port Overview123
- Configuring Ethernet Ports126
- Ethernet Port Configuration Example133
- Troubleshooting Ethernet Port Configuration133
  - Link Aggregation134
Section 8135
- Chapter 1 Link Aggregation Configuration136
Section 9147
- Chapter 1 MAC Address Table Management148
- Overview148
- MAC Address Table Management151
  - Configuring a MAC Address Entry and the Aging Time151
  - Setting the Maximum Number of MAC Addresses a Port Can Learn151
- Configuration Example152
- Displaying and Maintaining a MAC Address Table152
Section 10155
- Chapter 1 MSTP Configuration157
- Root Bridge Configuration163
- Leaf Node Configuration180
- The Mcheck Configuration186
  - Prerequisites186
  - Configuration Example187
- Protection Function Configuration188
- Digest Snooping Configuration192
  - Introduction192
  - Digest Snooping Configuration193
- Rapid Transition Configuration194
  - Introduction194
  - Rapid Transition Configuration196
- MSTP Displaying and Debugging197
- MSTP Implementation Example197
Section 11202
- Chapter 1 802.1X Configuration203
- Chapter 2 HABP Configuration226
- Chapter 3 System-Guard Configuration228
Section 12232
- Chapter 1 AAA&RADIUS Configuration233
- AAA Configuration240
- Configuration Tasks240
- Dynamic VLAN Assignment Configuration246
- RADIUS Configuration249
- Displaying AAA&RADIUS Information261
- AAA&RADIUS Configuration Example262
  - Remote RADIUS Authentication of Telnet/Ssh Users262
  - Local Authentication of Ftp/Telnet Users264
- Troubleshooting AAA&RADIUS Configuration265
  - Centralized Mac Address Authentication267
Section 13268
- Centralized MAC Address Authentication Overview269
- Chapter 1 Centralized MAC Address Authentication Configuration269
- Centralized MAC Address Authentication Configuration270
- Displaying and Debugging Centralized MAC Address Authentication272
- Centralized MAC Address Authentication Configuration Example273
Section 14276
- Chapter 1 ARP Configuration277
- Introduction to ARP277
- ARP Configuration281
- Gratuitous ARP Packet Learning Configuration282
  - Configuring Sending of Gratuitous ARP Packets282
  - Configuring the Gratuitous ARP Packet Learning Function282
- Displaying and Debugging ARP283
Section 15285
- Chapter 1 DHCP-Snooping Configuration286
Section 16290
- Chapter 1 ACL Configuration291
- Introduction to ACL291
  - ACL Implementation Mode on Switch291
- ACL Supported by S3100 Series Switches292
- Time Range Configuration292
  - Configuration Procedure293
  - Configuration Example293
- Time Range-Based ACL292
  - Introduction to Time Range292
  - Implementation of Time Range-Based ACL292
- ACL Configuration294
Section 17301
- Chapter 1 Qos Configuration303
- Qos Overview303
- Qos Functions and Related Commands305
- Configuring Port Priority306
  - Configuration Procedure307
  - Configuration Example307
- Configuring Packet Trust Priority307
  - Configuration Example308
- Configuring Priority - Local Precedence Queue Mapping308
- Configuring Packet Priority311
- Configuring Queue Scheduling Algorithm313
- Configuring Local Port Monitoring314
- Configuring RSPAN316
- Setting Rate Limit on Ports322
- Configuring Unknown Multicast Packet Discarding324
  - Displaying and Maintaining Qos324
  - Igmp Snooping326
Section 18327
- Chapter 1 IGMP Snooping Configuration328
- Chapter 2 Routing Port Join to Multicast Group Configuration342
Section 19346
- Chapter 1 Stack347
- Chapter 2 Cluster353
Section 20368
- Chapter 1 SNMP Configuration369
- SNMP Overview369
- Configuring SNMP Basic Functions371
- Configuring Trap374
  - Configuration Prerequisites374
  - Configuration Tasks374
- Displaying SNMP375
- SNMP Configuration Example376
Section 21379
- Chapter 1 RMON Configuration380
- Introduction to RMON380
  - Working Mechanism of RMON380
  - Commonly Used RMON Groups381
- RMON Configuration382
  - Configuring RMON382
- Displaying and Debugging RMON383
- RMON Configuration Example384
Section 22387
- Chapter 1 NTP Configuration388
- Introduction to NTP388
- NTP Implementation Mode Configuration392
  - Prerequisites393
  - Configuring NTP Implementation Modes393
- Access Control Permission Configuration395
- NTP Authentication Configuration395
  - Configuring NTP Authentication396
- Configuration of Optional NTP Parameters398
- Configuration Example399
- Displaying and Debugging NTP399
Section 23411
- Chapter 1 SSH Terminal Services412
- SSH Terminal Services412
- SFTP Service423
Section 24433
- Chapter 1 File System Management434
- File Attribute Configuration434
  - Introduction to File Attributes434
  - Configuring File Attributes435
- File System Configuration436
Section 25445
- Chapter 1 FTP and TFTP Configuration446
- FTP Configuration446
- TFTP Configuration454
Section 26460
- Information Center Overview461
- Chapter 1 Information Center462
- Information Center Configuration464
- Displaying and Debugging Information Center472
- Information Center Configuration Examples473
Section 27479
- Chapter 1 Bootrom and Host Software Loading481
- Chapter 3 IP Performance Configuration500
- Chapter 4 Network Connectivity Test503
  - Network Connectivity Test503
    - Ping503
    - Tracert503
- Chapter 5 Device Management505

Huawei Quidway S3100 Series

Table of Contents

Related product manuals