Hydac FCU 1310 - Change Name of Measurement Point

Select operating level / configuration menu
– Change name of measurement point
Under you can modify the designation of the measurement point
to meet your wishes. You have a maximum of 6 characters available for the
measurement point designation.
Example: TEST01, EXCAVATOR, CRANE, etc.
Use the following buttons:
Change to the next
option in the menu
To confirm the
change
Cancel and back
Use the following buttons:
Change to the next
option in the menu
To confirm the
change
Cancel and back
Use the following buttons:
Change the current
character
Select another
character
To confirm the
change
Cancel and back
FCU1310
en(us)
Page 64 / 124
BeWa FCU1310 V300 3371346f en-us 2017-01-27.docx 2017-01-27