Hypertherm HyPerformance Plasma HPR400 User Manual

Appendix B – CnC interfACe protoCol
HPR400XD Auto Gas – 806160 b-19
ID Command System Description
136 SERIAL_RESPONSE_DELAY All HPR systems Used when a CNC serial port can only support a half-duplex
connection. The HPR power supply will reduce its response
speed.
Data:
None
Return value:
1 if successful
Sample:
Send >1369A<, response >1361CB<
158 GET_SECONDARY_VERSION HPR800XD ONLY Get the software version of the secondary power supply
Data:
None
Return value:
The Secondary Power Supply software version
ex.”D.0”. “0.0” is returned if no secondary power supply is
connected and the power is on.
sample:
>1589E<
>158D.040<
Command table (14 of 14)

Hypertherm HyPerformance Plasma HPR400 Specifications

General

Duty Cycle	100% at 400 A
Cutting Capacity	up to 50 mm (2 in)
Output Current	30-400 A
Input Voltage	200 – 480 V, 3-PH, 50/60 Hz
Gas Supply	Oxygen, Air, Nitrogen