172
Chapter 5 Patterns / Variables
Figure 148. Defining a Pattern Character
5. Click Add to add the pattern character to the list. See Figure 148.
Next, set up a full pattern using the pattern character just defined.
6. Click the Pattern tab.
7. Type Length in the Name field. This is the name of the first pattern.
8. In the Pattern field, type #### for the pattern character to be used.
NOTE: The number of pattern characters that can be entered to form a
pattern is unlimited.
9. Click Add to add the pattern to the list.
10. Click New to clear the Name and Pattern fields.
11. Type Width in the Name field. This is the name of the second pattern.
12. In the Pattern field, type #### for the pattern character to be used.
To Next Page
Loading...
Need help?
General
