44
Chapter 2 The Menu Bar
Enable: To select whether or not you want to enable polling of a specific task.
If you want the PMU to poll the printers according to the specifications of your
first task, select true. Otherwise, select false.
Initial Delay (S): To specify the time delay from when the PMU starts to when
the PMU polls printers. The time delay is calculated in seconds.
Polled Interval (S): To poll printers automatically with timed intervals
calculated in seconds. Use this option to periodically poll for new printers
every few seconds.
Response Wait (MS): To specify the time delay the PMU waits between
SNMP responses. By default, the value is set at 300 milliseconds
(.3 seconds).
NOTE: If your network is overloaded and the responses are slow, you may
not receive a response with the default setting. In this case, increase
your Response Wait (MS) value.
NOTE: If you enter a low value for slow networks, you may receive no
response. In this case, increase the Response Wait (MS) value.
To Next Page
Loading...
Need help?
General
