74. Install the inner connector of the upper CMA to the inner member of the support rail......................... 70
75. Install the outer connector of the upper CMA to the outer member of the support rail........................ 70
76. Attach the support rail connector of the upper CMA to the right support rail........................................ 71
77. Comparing the location of the components of the CMA assemblies.......................................................71
78. Aligning the 2145-92F top cover..............................................................................................................72
79. Replacing the 2145-92F top cover...........................................................................................................73
80. Locking the top cover................................................................................................................................73
81. Drive assembly..........................................................................................................................................74
82. Drive locations in a 5U expansion enclosure........................................................................................... 74
83. Correct drive installation...........................................................................................................................75
84. Incorrect drive installation....................................................................................................................... 75
85. Replace the drive ......................................................................................................................................76
86. Location of secondary expander modules............................................................................................... 78
87. LEDs on a secondary expander module................................................................................................... 78
88. Open the secondary expander module handles...................................................................................... 79
89. Replace the secondary expander module................................................................................................79
90. Fascia components on the expansion enclosure .................................................................................... 80
91. Replace fascia components on the expansion enclosure .......................................................................81
92. Preparing to install the power supply.......................................................................................................83
93. Install the power supply........................................................................................................................... 84
94. Power supply indicators............................................................................................................................84
95. Fascia components on the expansion enclosure .................................................................................... 85
96. Remove fascia components from the expansion enclosure ...................................................................86
97. Fascia removed from the PSUs ................................................................................................................87
98. Correct orientation for SAS cable connectors..........................................................................................88
x