24. Install the bracket assembly to the frame............................................................................................... 22
25. Insert the chassis into the rack................................................................................................................ 23
26. Parts for installing the SAN Volume Controller 2145-SV1 CMA assembly............................................. 24
27. Reversing the orientation of the assembly...............................................................................................25
28. Install the inner member.......................................................................................................................... 25
29. Install the outer member..........................................................................................................................26
30. Install the other outer member................................................................................................................ 26
31. Ethernet ports on the rear of the SAN Volume Controller 2145-SV1 .....................................................27
32. Fibre Channel ports...................................................................................................................................27
33. SAN Volume Controller 2145-SV1 front panel.........................................................................................28
34. SAN Volume Controller 2145-SV1 operator-information panel..............................................................29
35. Expansion enclosure support rails........................................................................................................... 31
36. Installing the rail spring............................................................................................................................ 32
37. Hole locations in the front of the rack...................................................................................................... 33
38. Opening the hinge brackets......................................................................................................................34
39. Closing the hinge brackets........................................................................................................................34
40. Removing enclosure end caps..................................................................................................................35
41. Inserting the enclosure into the rack....................................................................................................... 36
42. SAS cable connector orientation.............................................................................................................. 37
43. Connecting the SAS cables....................................................................................................................... 38
44. Features on the front of the 2145-92F expansion enclosure..................................................................50
45. Front fascia of the 2145-92F expansion enclosure.................................................................................51
46. Features on the rear of the 2145-92F expansion enclosure...................................................................51
47. 2145-92F support rails.............................................................................................................................52
48. 2145-92F CMA assemblies...................................................................................................................... 53
viii
To Next Page
Loading...
