7. Make sure that the battery holder is secured firmly on the air baffle.
8. Install the filler.
9. Install the cover “Installing the cover” on page 206.
10. Slide the server into the rack.
11. Reconnect the power cords and all external cables, and turn on the server and
peripheral devices.
Removing the bezel
To remove the bezel, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 191.
2. Remove all the cables that are connected to the front of the server.
3. Remove the screws from the bezel.
4. Rotate the top of the bezel away from the server.
210 IBM System x3650 M4 Type 7915: Problem Determination and Service Guide
To Next Page
Loading...
