IBM System x3650 M4 Type 7915 - Removing a USB Hypervisor Memory Key

Removing a USB hypervisor memory key
USB embedded
hypervisor
flash device
Lockbar
To remove a USB hypervisor memory key, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 191.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables.
3. Slide the server out of the rack.
4. Remove the cover (see “Removing the cover” on page 205).
5. Unlock the retention latch on the USB connector by squeezing the two retention
clips toward each other.
6. Open the retention latch.
7. Grasp the flash device and pull to remove it from the connector.
8. If you are instructed to return the hypervisor memory key, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Note: You must configure the server not to look for the hypervisor USB drive. See
“Configuring the server” on page 298 for information about disabling hypervisor
support.
216 IBM System x3650 M4 Type 7915: Problem Determination and Service Guide