Installing the bezel
To install the bezel, complete the following steps.
1. Insert the tabs on the bottom of the bezel into the slots on the underside of the
chassis and attach it with the screws.
2. Connect any cables you previously removed from the front of the server.
Removing the 240 VA safety cover
To remove the 240 VA safety cover, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 191.
2. Turn off the server, and disconnect all power cords and external cables.
3. Pull the server out of the rack.
4. Remove the server cover (see “Removing the cover” on page 205).
5.
Chapter 5. Removing and replacing server components 211
To Next Page
Loading...
