To Next Page

To Previous Page

CAUTION:

When replacing the lithium battery, use only IBM Part Number 33F8354 or an

equivalent type battery recommended by the manufacturer. If your system has

a module containing a lithium battery, replace it only with the same module

type made by the same manufacturer. The battery contains lithium and can

explode if not properly used, handled, or disposed of.

Do not:

v Throw or immerse into water

v Heat to more than 100°C (212°F)

v Repair or disassemble

Dispose of the battery as required by local ordinances or regulations.

See the IBM Environmental Notices and User's Guide on the IBM Documentation

CD for more information.

To install the replacement battery, complete the following steps:

1. Follow any special handling and installation instructions that come with the

replacement battery.

2. Insert the new battery:

a. Tilt the battery so that you can insert it into the socket on the side opposite

the battery clip.

Battery

b. Press the battery down into the socket until it clicks into place. Make sure

that the battery clip holds the battery securely.

c. If you removed a rubber cover from the battery holder, use your fingers to

install the battery cover on top of the battery connector.

3. Reinstall any adapters that you removed.

276 IBM System x3650 M4 Type 7915: Problem Determination and Service Guide

IBM System x3650 M4 Type 7915 Specifications

General

Form Factor	2U Rack
Chipset	Intel C600 series chipset
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware vSphere
Processor	Up to two Intel Xeon E5-2600 series processors
Memory	Up to 768GB DDR3 (24 DIMM slots)
Storage	Up to 16 x 2.5" or 6 x 3.5" SAS/SATA HDDs or SSDs
RAID Support	RAID 0, 1, 10
Network	Four integrated Gigabit Ethernet ports
Power Supply	Up to two redundant hot-swap 550 W, 750 W, or 900 W power supplies
Expansion Slots	Up to 7 PCIe 3.0 slots
Storage Controller	ServeRAID M5110e
Management	Integrated Management Module (IMM) v2