Select this choice to view or change the operating profile (performance and
power utilization).
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI video output standards.
- Rehook INT 19h
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are non-UEFI compliant.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- Commands on USB Interface Preference
Select this choice to enable or disable the Ethernet over USB interface on
IMM2.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM2 MAC address, the current IMM2 IP address, and host name;
define the static IMM2 IP address, subnet mask, and gateway address,
specify whether to use the static IP address or have DHCP assign the
IMM2 IP address, save the network changes, and reset the IMM2.
- Reset IMM to Defaults
Select this choice to view or reset IMM2 to the default settings.
- Reset IMM
Select this choice to reset IMM2.
– System Security
Select this choice to view or configure Trusted Platform Module (TPM)
support.
– Adapters and UEFI Drivers
Select this choice to view information about the UEFI 1.10 and UEFI 2.0
compliant adapters and drivers installed in the server.
v Date and Time
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).
This choice is on the full Setup utility menu only.
v Start Options
Select this choice to view or change the start options, including the startup
sequence, PXE boot option, and PCI device boot priority. Changes in the startup
options take effect when you start the server.
The startup sequence specifies the order in which the server checks devices to
find a boot record. The server starts from the first boot record that it finds. If the
server has Wake on LAN hardware and software and the operating system
supports Wake on LAN functions, you can specify a startup sequence for the
Chapter 6. Configuration information and instructions 303
To Next Page
Loading...
Need help?
General
