Installing a PCI riser-card assembly ................219
Removing a PCI adapter from a PCI riser-card assembly ........221
Installing a PCI adapter in a PCI riser-card assembly .........222
Removing the optional dual-port network adapter ...........224
Installing the optional dual-port network adapter ...........225
Removing an optional ServeRAID upgrade adapter ..........229
Installing an optional ServeRAID upgrade adapter ..........230
Removing a remotely installed ServeRAID adapter battery .......231
Installing a ServeRAID SAS controller battery on the remote battery tray 232
Removing a ServeRAID SAS controller battery holder .........235
Installing a ServeRAID SAS controller battery holder .........235
Removing a hot-swap hard disk drive ...............236
Installing a hot-swap hard disk drive ...............237
Removing a simple-swap hard disk drive ..............238
Installing a simple-swap hard disk drive ..............238
Removing the SAS hard disk drive backplane ............240
Installing the SAS hard disk drive backplane ............240
Removing the simple-swap hard disk drive backplate .........242
Installing the simple-swap hard disk drive backplate ..........242
Removing an optional CD-RW/DVD drive..............244
Installing an optional CD-RW/DVD drive ..............245
Removing the DVD drive cable .................245
Installing the DVD drive cable ..................246
Removing an optional tape drive .................247
Installing an optional tape drive .................249
Removing a memory module (DIMM) ...............250
Installing a memory module...................250
Installing a DIMM ......................256
Removing a hot-swap dual-motor hot-swap fan ...........257
Installing a hot-swap dual-motor hot-swap fan ............258
Removing a hot-swap ac power supply ..............259
Installing a hot-swap ac power supply ...............259
Removing a hot-swap dc power supply ..............262
Installing a hot-swap dc power supply ...............266
Removing an optional remotely installed ServeRAID adapter battery....271
Installing an optional ServeRAID SAS controller battery on the remote
battery holder .......................272
Removing the battery .....................273
Installing the battery .....................275
Removing the operator information panel assembly ..........277
Installing the operator information panel assembly ..........278
Removing and replacing Tier 2 CRUs ................278
Removing a microprocessor and heat sink .............279
Installing a microprocessor and heat sink..............282
Thermal grease .......................287
Removing a heat-sink retention module ..............289
Installing a heat-sink retention module ...............289
Removing the system board ..................290
Installing the system board ...................292
Chapter 6. Configuration information and instructions ........297
Updating the firmware ......................297
Configuring the server ......................298
Using the ServerGuide Setup and Installation CD...........299
Using the Setup utility .....................301
Using the Boot Manager program ................306
Contents v
To Next Page
Loading...
Need help?
General