IBM System x3650 M4 Type 7915 - Page 72

Table 6. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
800b0509-1301xxxx Non-
redundant:Insufficient
Resources for Power
Resource has
asserted.
Error A change to the
insufficiency status
of the power
supply has
happened.
1. Power load may be handled by
remaining power supply. The
system will attempt to throttle to
avoid a power supply over-current
condition. But a system shutdown
may happen anyway if the power
load is too great. See
“Power-supply LEDs” on page 135
for more information.
2. Reduce the total power
consumption by removing newly
added or unused options like drives
or adaptors.
3. Use the IBM Power Configurator
utility to determine current system
power consumption. For more
information and to download the
utility, go to http://www-03.ibm.com/
systems/bladecenter/resources/
powerconfig.html.
4. Replace the power supply with
higher rated power.
806f0008-0a01xxxx
806f0008-0a02xxxx
The Power Supply
(Power Supply n)
presence has been
detected.
(n = power supply
number)
Info Power supply n
has been added.
(n = power supply
number)
No action; information only.
806f0009-1301xxxx The Power Supply
(Power Supply n) has
been turned off.
(n = power supply
number)
Info Power supply n
has been turned
off.
(n = power supply
number)
No action; information only.
806f0108-0a01xxxx
806f0108-0a02xxxx
The Power Supply n
has failed.
(n = power supply
number)
Error Power supply n
has failed.
(n = power supply
number)
1. Reseat power supply n.
2. If the power-on LED is not lit and
the power-supply error LED is lit,
replace power supply n.
3. If both the power-on LED and the
power-supply error LED are not lit,
see “Power problems” on page 115
for more information.
(n = power supply number)
806f0109-1301xxxx The Power Supply n
has been Power
Cycled.
(n = power supply
number)
Info Power supply n
has been power
cycled.
(n = power supply
number)
No action; information only.
54 IBM System x3650 M4 Type 7915: Problem Determination and Service Guide