Table 45. Main error events (continued)
Event Code Message Text and
Description
Details and Solution
2095 Inventory scan failed because
of accessor positioning
problem.
Check for obstructions in the horizontal pathway of the
accessor such as a cartridge that is sticking out or lying on
the accessor table.
2096 Initializing a communication
interface on the library
controller failed.
Restart the library, and if the error persists, replace the library
controller.
2097 Accessor reinitialization failed. Restart the library and if the error persists, replace the
accessor assembly.
2100 Robotic move to requested
position failed.
• Check for obstructions in the pathway of the accessor such
as a cartridge that is sticking out.
• Verify module alignment and frame alignment.
• Check if the accessor is stuck in the lock mechanism. Move
the accessor away from the lock mechanism and enable the
lock mechanism correctly.
2103 Incorrect stack assembly,
too many expansion modules
below main library.
Ensure that no more than three expansion modules are
mounted and connected below or above main library.
2104 Incorrect stack assembly,
too many expansion modules
above main library.
Ensure that no more than three expansion modules are
mounted and connected below or above main library.
2105 Accessor initialization failed
due to horizontal positioning
problem.
• Check for obstructions in the horizontal pathway of the
accessor such as a cartridge sticking out or lying on the
accessor's table.
• The accessor shipping lock might be positioned incorrectly
and must be moved to either the fully locked or fully
unlocked position.
2106 An elevator block was
detected and as a result the
system was taken offline.
• Check for obstructions in the vertical pathway of the robot,
such as a cartridge sticking out. Also, verify alignment of the
module and the frame.
• Follow these steps to check for any obstructions at the
bottom of the library or on the bottom cover of the library:
1. Turn off the library by pressing the front power button for
5 seconds, and select Default Park location.
2. Remove the left magazine of the lowest library module.
3. Remove any objects from the bottom cover that might
obstruct the robot's path.
4. Replace the magazine.
5. Power on the library.
6. After the library îš´nishes initialization and inventory, verify
that no further critical events were generated.
IBM Conîš´dential
Chapter 5. Troubleshooting123
To Next Page
Loading...
Need help?
General
