EasyManuals Logo

IBM TS4300 User Manual

IBM TS4300
324 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
• When possible, use one hand only to connect or disconnect signal
cables.
• Never turn on any equipment when there is evidence of re, water, or
structural damage.
• Do not attempt to switch on power to the machine until all possible
unsafe conditions are corrected.
• Assume that an electrical safety hazard is present. Perform all
continuity, grounding, and power checks speciîš´ed during the
subsystem installation procedures to ensure that the machine meets
safety requirements.
• Do not continue with the inspection if any unsafe conditions are
present.
• Before you open the device covers, unless instructed otherwise in
the installation and conîš´guration procedures: Disconnect the attached
AC power cords, turn off the applicable circuit breakers located
in the rack power distribution panel (PDP), and disconnect any
telecommunications systems, networks, and modems.
• Connect and disconnect cables as described in the following
procedures when installing, moving, or opening covers on this product
or attached devices.
To disconnect:
1. Turn off everything (unless instructed otherwise).
2. For AC power, remove the power cords from the outlets.
3. For racks with a DC power distribution panel (PDP), turn off the
circuit breakers located in the PDP and remove the power from the
Customer's DC power source.
4. Remove the signal cables from the connectors.
5. Remove all cables from the devices.
To connect:
1. Turn off everything (unless instructed otherwise).
2. Attach all cables to the devices.
3. Attach the signal cables to the connectors.
4. For AC power, attach the power cords to the outlets.
5. For racks with a DC power distribution panel (PDP), restore the power
from the Customer'sDC power source and turn on the circuit breakers
located in the PDP.
6. Turn on the devices.
• Sharp edges, corners and joints may be present in and around the
system. Use care when handling equipment to avoid cuts, scrapes and
pinching. (D005)
Heavy equipment - personal injury or equipment damage might result if
mishandled. (D006)
IBM Conîš´dential
xxiiIBM TS4300 Tape Library Machine Type 3555: User's Guide

Table of Contents

Other manuals for IBM TS4300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM TS4300 and is the answer not in the manual?

IBM TS4300 Specifications

General IconGeneral
Product TypeTape Library
Form FactorRack-mountable
Host Interface8 Gb Fibre Channel, 6 Gb SAS
Humidity20% to 80% non-condensing
Number of Drives SupportedUp to 3
Drive Type SupportedLTO Ultrium 8, LTO Ultrium 7
EncryptionYes
Remote ManagementYes (web-based interface)
Supported MediaLTO Ultrium 8, LTO Ultrium 7
Power Supply100-240 VAC, 50/60 Hz

Related product manuals