Section 4 - Installation
INSTALLATION
40 Installation and Maintenance
4.2 INSTALLATION OF INDOOR DHW CYLINDER
4.2.1 Receival and Unpacking
Packaging Symbols
The below symbols and conditions must always be followed
for the packaged product.
Do not clamp from these sides when handling
Do not tilt the package
Product must be treated as fragile
Keep package away from water and rain
Product should not be discarded as unsorted waste but
must be sent to separate collection facilities for recovery
and recycling
ⓘ IMPORTANT: The DHW Cylinder MUST be kept
upright at ALL times.
ᘐ WARNING: Packaging straps are tightly secured
and can release a lot of kinetic energy when cut. Hold
straps rmly and apply caution when cutting and keep
body away during cutting to avoid injury.
cardboard sleeving / packaging and is to be removed in
following the below sequence:
1. Remove the packaging straps by cutting them away
from the body.
2. Lift the cardboard outer lid from the packaging.
3. Remove the inner cardboard cylinder cover.
4. Remove the inner cardboard corner supports.
5. Remove the outer cardboard sleeves.
6.
the pallet. The Cylinder can now be removed from the
pallet.
It is the responsibility of the system installer to correctly
dispose and recycle the product packaging.
After the product is unpacked, make sure that all the
contents listed below are present.
Quantity Item Description
1
1 Documentation Package
(refer to Table 10 on page 21)
To Next Page
Loading...