IDS X Series Installer Manual

IDS X-Series Installer Manual 700-398-02H Issued July 2013
71
21. Trouble Display
A trouble condition is indicated by the power LED on the keypad flashing.
To view what the trouble condition, hold the 7 key for 3 seconds.
To cancel the trouble condition, once it has been rectified, go into viewing the trouble condition and then press
#.
No.
Trouble
Description
1
AC Fail
16V AC has gone missing
2
Communication Failed
The alarm has tried to communicate with the reaction
company and failed
3
Phone line tamper
The system has detected that the phone line is no longer
connected
4
Siren tamper
The system has detected that the siren is no longer
connected
5
Battery Trouble
The battery has been removed or is faulty
6
AUX 12V trouble
The fuse is faulty or a device is causing a power issue
7
Engineer reset
The installer code must be entered before the system may be
armed
8
Box Trouble
The box tamper has been violated
9
Bus device tamper
A device connected to the keypad bus has been tampered
10
Bus device communication
A device connected to the keypad bus has lost
communication with the system
11
Bus device power
A device connected to the keypad bus has lost power
12
Wireless detector battery low
A wireless detector’s battery is low and must be replaced
13
Wireless detector supervision
failure
Communication to a wireless detector has gone missing
14
Wireless receiver jam
Wireless receiver has detected a signal that is causing it to
lose communication with all devices
15
Wireless detector RSSI trouble
The signal being received from a detector is too low
16
Zone Tamper
A zone has experienced a tamper

IDS X Series Specifications

General

Brand	IDS
Model	X Series
Category	Keypad
Language	English