PPC-5190 Flat Panel PC
Page 91
Configure S-ATA as RAID [No]
The Configure S-ATA as RAID option can only be selected if the IDE Configuration option
is set to “P-ATA Only”. Use Configure S-ATA as RAID option to configure the S-ATA
interface as RAID.
No DEFAULT
The S-ATA interface cannot be configured as RAID drive.
Yes
The S-ATA interface can be configured as RAID drive.
Hard Disk Write Protect [Disabled]
The Hard Disk Write Protect BIOS option protects the hard disks from being overwritten.
This menu item is only effective if the device is accessed through the BIOS.
Disabled DEFAULT
Allows hard disks to be overwritten
Enabled
Prevents hard disks from being overwritten
IDE Detect Time Out (Sec) [35]
The IDE Detect Time Out (Sec) BIOS option specifies the maximum time (in seconds) the
AMI BIOS will search for IDE devices. This allows fine-tunes the settings to allow for faster
boot times. The following configuration options are available.
0 seconds
5 seconds
10 seconds
15 seconds
20 seconds
25 seconds
30 seconds
35 seconds DEFAULT
The best setting to use if the onboard IDE controllers are set to a specific IDE disk drive in
the AMIBIOS is “0 seconds” and a large majority of ultra ATA hard disk drives can be
detected well within “5 seconds” (the default setting).
To Next Page
Loading...
Need help?
General