13
RDX A8 User and Service Guide — Version 1.0
ii. Installation precautions
Select a location that meets the following criteria:
CAUTION
Static sensitive
Risk of damage to devices
• A discharge of static electricity damages static-sensitive
devices or micro circuitry.
• Proper packaging and grounding techniques are
necessary precautions to prevent damage.
NOTICE
• Do not expose the unit to moisture.
• Use the unit on a firm level surface free from vibration.
• Do not place anything on top of the unit.
iii. Unpacking the unit
Before unpacking the unit, clear a work surface to unpack the RDX A8. Select either a table top location
or if the unit is to be rack mounted an open rack location at least 2U spaces in vertical height.
Make sure that the intended operating location provides access to the network connection(s)
which will be used and an accessible AC power outlet within 6 ft. of the unit.
NOTICE
If the temperature in the room where the unit will be installed
varies by 15º C (30º F) from the room where the unit was stored,
allow the unit to acclimate to the surrounding environment for at
least 12 hours before unpacking it from the shipping container.
Unpacking the RDX A8:
1. Before opening and removing the RDX A8 from the box, inspect the container for shipping
damage. If you notice any damage, report it to the shipping company immediately.
2. Open the RDX A8 over pack box.
3. Carefully remove the accessory tray and shipping materials from the top of the over pack box.
4. Remove the inner box containing the RDX A8.
5. Open the RDX A8 box.
6. Lift the RDX A8 out of the carton and remove the bag from the unit.
7. Save the packaging materials for future use.
NOTICE
Do not place the unit on either end or sides as this may
damage the unit.
To Next Page
Loading...
