Immergas VICTRIX EXTRA 12 PLUS - Assembling the Manifold on the Condensation Module

118
INSTALLER
USERMAINTENANCE TECHNICIAN
TECHNICAL DATA
3.26 ASSEMBLING THE MANIFOLD ON THE CONDENSATION MODULE
1. Set the manifold on the module.
2. Tighten the 4 nuts (1) on the condensation module (3) according to the sequence (A, B, C, D) indicated in the drawing.
e tightening torque when assembling the manifold (2) on the condensation module (3) must be 4 Nm.
Do not exceed 5 Nm.
1
2
3
A
B
C
D
91