Immergas VICTRIX EXTRA 12 PLUS - System Filling; Filling the Condensate Drain Trap; Gas System Start-Up

55
INSTALLER
USERMAINTENANCE TECHNICIAN
TECHNICAL DATA
1.28 SYSTEM FILLING
Once the appliance is connected, proceed with system lling via the lling cock (Part. 1, Fig. 7).
Filling is performed at low speed to ensure release of air bubbles in the water via the appliance and central heating system vents.
e appliance has a built-in automatic vent valve on the pump (Fig. 47).
en open the radiator vent valves.
Close radiator vent valves when only water escapes from them.
e lling valve must be closed when the appliance pressure gauge indicates approximately 1.2 bar cold.
During these operations, enable the automatic vent functions on the appliance (Parag. 3.17);
1.29 FILLING THE CONDENSATE DRAIN TRAP
When the appliance is switched on for the rst time, combustion products come out of the con-
densate drain. Aer a few minutes of operation, check that combustion ue gases are no longer
coming out of the condensate drain; this means that the drain trap has lled to a correct con-
densate height that the ue gases cannot pass through.
1.30 GAS SYSTEM STARTUP
To start up the system, refer to the technical standards in force.
is divides the systems and, therefore, the commissioning operations, into three categories: new systems, modied systems, reactivated
systems.
In particular, for new gas systems:
- open windows and doors;
- avoid presence of sparks or naked ames;
- bleed all air from pipelines;
- ensure the internal system is properly sealed according to the specications set forth by technical regulations in force.