7 Signalling LEDs 78
7.1 Power and motor signalling LEDs 79
7.2 CAN signalling LEDs 79
7.3 EtherCAT signalling LEDs 80
7.3.1 EtherCAT status LED 81
7.3.2 EtherCAT in-connector LED 81
8 Software 82
8.1 Installing MotionLab Configuration Software 83
8.1.1 Before you begin 83
8.1.2 Hardware Installation: 83
8.1.3 Software Installation and Drive Communication Setup: 83
8.2 Updating your drive Firmware 84
8.3 Configuring your drive 85
9 Dimensions 85
9.1 Standard version 86
9.2 EtherCAT version 86
10 Disclaimers and limitations of liability 87
Manual revision History
To Next Page
Loading...