Note:
You do not need to specify the flash device for .rpd files because the .rpd format is independent of the flash
device. In contrast, the .poc and .jic files include both programming data and additional data specific to the
configuration device. The Intel Quartus Prime Programmer uses this additional data to establish communication with
the configuration device and then write the programming data.
9. Click Generate to generate the programming file or files.
Related Information
Intel Quartus Prime Pro Edition User Guide: Programmer
For comprehensive information about programming file generation and conversion.
3.2.10.2. Programming .pof files into Serial Flash Device
To program the .pof into the serial flash device through the AS header, perform the following steps:
1. In the Programmer window, click Hardware Setup and select the desired download cable.
2. In the Mode list, select Active Serial Programming.
3. Click Auto Detect button on the left pane.
4. Select the device to be programmed and click Add File.
5.
Select the .pof to be programmed to the selected device.
6. Click Start to start programming.
3.2.10.3. Programming .jic files into Serial Flash Device
To program the .jic into the serial flash device through the JTAG interface, perform the following steps:
1. In the Programmer window, click Hardware Setup and select the desired download cable.
2. In the Mode list, select JTAG.
3. Select the device to be programmed and click Add File.
4.
Select the .jic to be programmed to the selected device.
5. Click Start to start programming.
3.2.11. Debugging Guidelines for the AS Configuration Scheme
3. Intel Agilex Configuration Schemes
UG-20205 | 2019.10.09
Intel
®
Agilex
™
Configuration User Guide
Send Feedback
106
To Next Page
Loading...
Need help?
General
