Related Information
rsu1.tcl
4.6.4. Reconfiguring the Device with an Application or Factory Image
The following steps describe the process to reconfigure the device with a different application image or the factory image
using operation commands after the device is in user mode.
1.
The remote system update host sends the RSU_IMAGE_UPDATE command to perform the remote system update to the
new application image or factory image.
a. For example, in the Tcl console of the System Console, type the following command to initiate a remote system
update to the factory image.
i.
rsu_image_update 0x00110000
This command reconfigures the device with factory image. Address 0x00110000 is the start address of the
factory image as shown in the .map file. The JTAG host automatically disconnects from the System Console once
the device reconfiguration is successful. You must restart the System Console to re-establish the connection with
the device to perform next command.
ii.
rsu_image_update 0x002F4000
This command reconfigures the device with the application image. Address 0x002F4000 is the start address of
the application image as shown in the .map file.
Optional: Retrieve the remote system update status by using the rsu_status command to ensure you have successfully
reconfigured the device.
2.
In the Tcl console of the System Console, type rsu_status to verify the current image. The following figure shows the
device is being reconfigured with the factory image.
4. Remote System Update (RSU)
UG-20205 | 2019.10.09
Send Feedback
Intel
®
Agilex
™
Configuration User Guide
171
To Next Page
Loading...
Need help?
General
