c. Select the AS clock frequency from the Active serial clock source drop-down list.
3. Click OK to confirm and close the Device and Pin Options.
3.2.10. Intel Quartus Prime Programming Steps
3.2.10.1. Generating Programming Files using the Programming File Generator
By default, the Intel Quartus Prime Compiler's Assembler module generates the primary files required for device programming
at the end of full compilation. Primary programming files include the .sof, .pof, and .rpd. You can use the Programming
File Generator to generate programming files for alternative device programming methods, such as the .jic for flash
programming,.rbf for partial reconfiguration, or .rpd for third-party programmer configuration. The Programming File
Generator supports Intel Stratix
®
10 and later devices. The legacy Convert Programming Files dialog box does not
support some advanced programming features for Intel Stratix 10 and later devices.
Note:
If you are generating an .rpd for remote system update (RSU), you must follow the instructions in Generating an Application
Image on page 153 in the Remote System Update chapter. This procedure generates flash programming files for Intel Agilex
devices.
Complete the following steps generate the programming file or files you require:
1. Click File Programming File Generator.
2. For Device Family select Intel Agilex
3. In the Configuration mode, select Active Serial x4.
4. Specify the Output directory and Name for the file you generate.
5. Under Output directory, select the appropriate file type for your design. The AS scheme supports the Programmer
Object File (.pof), JTAG Indirect Configuration File (.jic), and Raw Programming Data File (.rpd) file types.
3. Intel Agilex Configuration Schemes
UG-20205 | 2019.10.09
Intel
®
Agilex
™
Configuration User Guide
Send Feedback
102
To Next Page
Loading...
Need help?
General
