ESim v5.12 for EasyCoder PD4—Programmer’s Reference Manual 99
Chapter 7—Commands
S – Speed Select
Description is command is used to select the print speed.
Syntax Sp
1
Parameters p
1
Speed select value:
0 30 mm/sec. (1.2 inches/sec.)
1 40 mm/sec. (1.6 inches/sec.)
2 50 mm/sec. (2 inches/sec.)
3 75 mm/sec. (3 inches/sec.)
4 100 mm/sec. (4 inches/sec.) Default
5 125 mm/sec. (5 inches/sec.) 203.2 dpi (8 dots/mm) printers only.
6 150 mm/sec. (6 inches/sec.) 203.2 dpi (8 dots/mm) printers only.
Remarks Changing the print speed will affect the blackness of the print-
out, which may have to be adjusted using a D command.
Example S2↵ :Sets the print speed to 50 mm/sec. (2 inches/sec.).
To Next Page
Loading...
