Intermec EasyCoder PD4 Programmer's Reference Manual

14 ESim v5.12 for EasyCoder PD4—Programmer’s Reference Manual
Chapter 3—Setting Up the Printer
Default Setup
Parameter Command Meaning
Error/Status Char.
eR0,0
XOFF/XON-handling
Density
D10
10
Character Set
I8,0,001
8 bits, code page 0, country code 001
Top of Form backup
JF
Enabled
Media feed adjust
j136
j204
136 dots (at 203.2 dpi)
204 dots (at 300 dpi)
Options
ON,D
LTS disabled, DT mode, reverse gap disabled,
cutter disabled
Char. substitution
oR
No substitution
Form Length
Q24,0
Continuous mode, print gap 24 dots
Label Width
q832
q1208
832 dots (at 203.2 dpi)
1208 dots (at 300 dpi)
Reference Point
R000,000
X:000;Y000
Print Speed
S3
75 mm/sec. (3 inches/sec.)
Date Format
TDme/dd/Y4
For example JAN/15/2004
Time Format
TTh:m:s
For example 13:25:00
Reply character
UC0
None
Error Handling
US
Error reporting enabled
Windows Mode
WN
Disabled
Serial Port
Y96,N,8,1
9600 baud, no parity, 8 data bits, 1 stop bit
Print Direction
ZT
Start printing at top of image buffer
Printhead Resolution Measures
203.2 dpi printheads 203.2 dpi (8 dots/mm) in both directions
300 dpi printheads 300 dpi (11.81 dots/mm) across the media path
304.8 dpi (12 dots/mm) along the media path
The setup will be reset to default values if the Cancel key is pressed more
than 3 seconds in the Dump Mode.

Intermec EasyCoder PD4 Specifications

General

Brand	Intermec
Model	EasyCoder PD4
Category	Label Maker
Language	English