122 ESim v5.12 for EasyCoder PD4—Programmer’s Reference Manual
Chapter 7—Commands
Z – Print Direction
Description is command is used to select the print orientation.
Syntax Zp
1
Parameters p
1
Print orientation:
T Start printing from the top of image buffer (default).
B Start printing from the bottom of image buffer.
Remarks is command affects the complete print image, including text,
bar codes, graphics, lines, and boxes, as well as the location of the
reference point (see R command).
Note that printing a test label in the Test Mode, or by means of
a U or UP command, will reset the print direction to default (=
ZT).
ZT Command:
ZB Command:
Example ZB↵ :Starts printing from the bottom of the image buffer.
To Next Page
Loading...
